Skip to content

Wake a Local Server from iPhone with NeoServer Wake-on-LAN

Save the server's MAC address in NeoServer, then send a local Wake-on-LAN packet from its metrics screen. WOL requires compatible hardware and Pro access.

1 min read

NeoServer can send a Wake-on-LAN (WOL) packet from an iPhone to a saved server. Enter the server’s WOL MAC address, then choose Wake On Lan from the server’s metrics actions. The feature may require Pro.

Set up the server and network

  1. Enable WOL in the target computer’s firmware and network adapter settings. Confirm it can wake from the power state you plan to use.
  2. Find the network adapter’s MAC address and save it in NeoServer’s server settings under WOL MAC.
  3. Connect the iPhone to the same local network as the target computer.
  4. In the server’s metrics actions, tap Wake On Lan.

NeoServer sends a UDP magic packet to the local broadcast address on port 9. Its WOL action uses the saved MAC address; a static IP or dynamic DNS name is not required for this local packet. Waking a device across the internet requires a separate network setup and is not guaranteed by these steps.

If nothing happens

Check the MAC address, firmware setting, network adapter power setting and local network isolation. Sending the packet only confirms the request was made; it does not prove the target powered on. Test WOL on the local network before investigating remote access.

Ready to try it?

NeoServer · SSH, Mosh, Docker & SFTP client for iPhone, iPad and Mac

Free on the App Store